Due to the Covid-19 emergency our factory and offices will be operating at a reduced level until further notice. We will be taking online orders but you should expect them to take longer to deliver than normal.

We will fully re-open only when the government tells us it is safe to do so.

We’re sorry for the inconvenience and we will be back in full force to do business with you in the future.

stone and brick protector
dead flat
  • stone and brick protector 1 litre
  • stone and brick protector 4 litre
zoom  click for a larger image

play

how-to video

absorbed into the substrate, this high performance coating protects interior and exterior stone and brick for a completely natural finish
A high performance water-based masonry protector and water repellent that penetrates into porous substrates forming a barrier to water, moisture, grease, oil acid, alkali and salts. Suppresses mould and fungal growth and the formation of salts on natural masonry surfaces.
It has a long service life, is highly UV resistant and leaves surfaces looking natural after application.

ideal for
• stone • plaster • brick • slate • flagstones • fireplaces • exposed stone walls • brick walls • stone window ledges

unique qualities
• waterproofs brick and stone • suppresses formation of salts on natural masonry surfaces •  improves weatherability • a moisture barrier - seals off the surface • resists penetration of grease, oil, acids, alkaline, salts • easily cleaned with mild soap and water


find a stockist shop online how-to video
options
zoom click for a larger image (Any colours shown are representations and should be used as guidance only. Colours when applied will vary according to the material they are used on.)
  • dead flatdead flat

at a glance product info

  • interior
    interior
  • exterior
    exterior
  • chemical resistant
    chemical resistant
  • quick drying
    quick drying
  • microporous
    microporous
  • nano technology
    nano technology
  • water wash up
    water wash up

available in: 1 litre • 4 litre



drying time: 15 minutes to 1 hour depending on temperature • coverage: 15-20 square metres per litre , depending on the porosity of the material


application and advice

preparation
Do not use in temperatures below 5°c/40°f or in very high humidity. Stone and brick protector should be used as supplied, without dilution, by brush, spray or roller.

application
Mix well before use.
For general applications on masonry, brickwork and stone, a single application will be sufficient.

caution
Always test on a trial area before application. Apply evenly and do not allow to pool in crevices. Test for clarity over dark colours.
NOTE: A chemical reaction could take place on some substrates such as glass, glazed surfaces, lead or aluminium. Mask these materials before application. In case of contact, rinse thoroughly with water immediately.

storage
Store in unopened containers in a cool dry place away from direct sunlight. Protect from extremes of temperature during storage and application.

health, safety and the environment
Non-hazardous. Ensure good ventilation.
Keep out of reach of children.
Contact with eyes - wash immediately with warm water.
Remove excess from tools and mixing vessels before washing in warm soapy water.
Do not empty into drains or watercourses.



ask our expert

find the right product for the job - adhesives heavy duty floor varnish decorators varnish crystal clear lacquer extra pale varnish heavy duty extreme varnish heavy duty wood varnish wood dye stone and brick protector wax finish varnish heavy duty extreme varnish stone and brick protector wood dye heavy duty wood varnish decorators varnish extra pale varnish crystal clear lacquer wax finish varnish heavy duty floor varnish

 

Polyvine on social media

 

facebook instagram twitter pinterest